DAS230-205
Double-tap and hold to zoom.
Mouse over the image to zoom.
Click to Enlarge

DAS 230 X 205 X 25.4

DAS230-205

UPC: 51968260

Untitled Document

 

DAS Style Compact Seals

(5 Piece Seal) *Unless Specified

The DAS style compact seals are self-acting double-acting seals. The radial forces acting on the elastic rubber sealing element after installation are superimposed by the system pressure. This results in a total sealing contact force which increases as the system pressure rises. Even when no system pressure is present, good sealing is achieved. A wide mounting surface also provides additional protection against shifting or twisting of the sealing element.


Applications:

The DAS compact seal is used as a sealing element for pistons and hydraulic cylinders for reciprocating motion such as earth moving machines, hydraulic excavators, cranes, forklift trucks, hydraulic tailgates, agricultural machines, etc.


Materials:

The inner sealing element is made of nitrile rubber (NBR), or Viton® (FKM) on select sizes, which is extremely wear-resistant and has a low compression set and high tensile strength. The material has a hardness of approximately 75 Shore A. The back-up rings are made from polyester elastomer with protective and additional lubricating additives, and the material is known for its high strength and heat resistance. The guide-rings are made of thermoplastic material reinforced with glass fibres and additional additives. This material is characterized by high pressure resistance and good resistance to alternating thermal stresses.


Advantages:

  • Closed groove, one piece piston.

  • Short-overall length of the piston.

  • Only one groove for seal and guidance.

  • Low cost production of the piston.

  • Free selection of piston material.

  • High resistance to gap extrusion.

  • No twisting or turning of the elastic sealing element.

  • Good leakage values.

  • Snap-on assembly possible.

  • Can be used to replace many other compact seal design.


Operating Ranges:

Pressure Range: up to 40MPa (400 bar)

Temperature Range: -40°C - +110°C (-40°F - +230°F) *Capable of higher temperature with use of Viton® sealing element*

Speed: up to 0.5 m/s

Operating Media: Hydraulic fluids and lubricants based on mineral oils.